伦茨i700驱动器常见故障
伦茨i700驱动器的常见故障,结合个人维修经验,主要有以下:
1.上电无显示(红灯、蓝灯均不亮)
2.上电报警(红灯常亮),常见报警代码如下:
专业维修LENZE伦茨i700伺服驱动器各种故障:
0x2320 Short circuit or earth leakage at the motor end
0x2340 Short circuit at the motor end
0x3210 DC bus - overvoltage [value] V
0x3220 DC bus - undervoltage [value] V
0x4210 Module temperature too high, [value]
0x4280 Internal fault - module temperature monitoring
0x4310 Motor temperature too high, [value]
0x4380 Motor temperature sensor
0x5112 24 V supply
0x7303 Error in feedback system
0x7380 Hiperface communication error
0xff00 Fatal internal error
0xff02 Brake
0xff09 Motor phase failure
0xff0a Motor phase failure - phase U
0xff0b Motor phase failure - phase V
0xff0c Motor phase failure - phase W
- 凡本网注明"来源:智能制造网"的所有作品,版权均属于智能制造网,转载请必须注明智能制造网,https://www.gkzhan.com。违反者本网将追究相关法律责任。
- 企业发布的公司新闻、技术文章、资料下载等内容,如涉及侵权、违规遭投诉的,一律由发布企业自行承担责任,本网有权删除内容并追溯责任。
- 本网转载并注明自其它来源的作品,目的在于传递更多信息,并不代表本网赞同其观点或证实其内容的真实性,不承担此类作品侵权行为的直接责任及连带责任。其他媒体、网站或个人从本网转载时,必须保留本网注明的作品来源,并自负版权等法律责任。
- 如涉及作品内容、版权等问题,请在作品发表之日起一周内与本网联系,否则视为放弃相关权利。