产品简介
IMG_20170528_104835.jpg(73.45KB,下载次数:98)下载附件2019-6-409:35上传D-Think_NFC010模块主核心采用NXP第二代NFC控制器PN544(PN65N)
产品介绍
D-Think_NFC010模块主核心采用NXP第二代NFC控制器PN544(PN65N)， NFC功能最完整，尺寸小，并集成了部分外围元件，采用3MIL线宽/间距生产工艺，缩短了开发周期，降低了开发难度。
| 产品编码 | D-Think_010_PN65N | | 协议标准 | ISO/IEC 14443A，ISO/IEC 14443 B，ISO/IEC 15693，
ISO/IEC 18092，FeliCa，Mifare 1K/4K | | 工作频率 | 13.56MHz | | 识别距离 | 5-8CM | | 安全模块 | 有 | | 供电 | USB供电 | | 外围芯片接口 | SWP、NFC‐WI | | 通讯接口 | UART、I2C、SPI | | 电气特性 | 与PN544(PN65N)相一致，见PN544(PN65N)数据手册 | | 外型尺寸 | 15*18*1.9mm | | 工作温度 | -40 - +65 ℃ | | 储存温度 | -25 - +85 ℃ |
产品特点
产品应用
传输模式
引脚定义
| 引脚号 | 引脚名称 | 类别 | 描述 | 备注 | | 1 | GND | Other | Ground |
| | 2 | NC | NC |
|
| | 3 | EXT_SW_CTRL | UICC | Control output signal for external UICC power switch |
| | 4 | NC | NC |
|
| | 5 | NC | NC |
|
| | 6 | NC | NC |
|
| | 7 | NC | NC |
|
| | 8 | A0/NSS (IF0) | Host | Functionality depends on selected interface |
| | 9 | NC | NC |
|
| | 10 | NC | NC |
|
| | 11 | NC | NC |
|
| | 12 | NC | NC |
|
| | 13 | NC | NC |
|
| | 14 | IFSEL2 | Configuration | Host interface select input 2 |
| | 15 | IFSEL1 | Configuration | Host interface select input 1 |
| | 16 | RST_N | SE | RST pin of ISO IEC 7816 interface of SmartMX | 仅PN65N | | 17 | VMID | Antenna | Contactless receiver Voltage reference |
| | 18 | RX | Antenna | Contactless Receiver input |
| | 19 | PF1 | Antenna | Antenna connection for card emulation |
| | 20 | NC | NC |
|
| | 21 | TX1 | Antenna | Contactless Transmitter output 1 |
| | 22 | TX2 | Antenna | Contactless Transmitter output 2 |
| | 23 | PF2 | Antenna | Antenna connection for card emulation |
| | 24 | GND | Other | Ground |
| | 25 | NC | NC |
|
| | 26 | SIGIN | SE | NFC-WI data input |
| | 27 | VEN_MON (LX) | Other | DCDC coil | PN544 | | Enable of the battery voltage monitor | PN65N | | 28 | I/O1 | SE | IO pin of ISO IEC 7816 interface of SmartMX | 仅PN65N | | 29 | VBAT | Power | Battery voltage |
| | 30 | SIGOUT | SE | NFC-WI data output |
| | 31 | SVDD | SE | SmartMX power,fixed to 1.8V |
| | 32 | SWP | UICC | SWP data connection |
| | 33 | SIMVCC | UICC | Power output to supply the UICC |
| | 34 | VEN | Host | Enable/disable LDO regulator |
| | 35 | PMUVCC | Host | UICC Power in from PMU |
| | 36 | CLK | SE | CLK pin of ISO IEC 7816 interface of SmartMX | 仅PN65N | | 37 | NRESET | Host | PN544有用，PN65N中接PVDD |
| | 38 | NC | NC |
|
| | 39 | SDA/SCK (IF2) | Host | Functionality depends on selected interface |
| | 40 | PVDD | Host | Pad supply voltage Input(VI/O) |
| | 41 | RXD/A1/MOSI (IF1) | Host | Functionality depends on selected interface |
| | 42 | IRQ | Host | IRQ output |
| | 43 | TXD/SCL/MISO (IF3) | Host | Functionality depends on selected interface |
| | 44 | IFSEL0 | Configuration | Host interface select input 0 |
| | 45 | GPIO5 | GPIO | Run mode selection | 仅PN65N | | 46 | GPIO4 | GPIO | Download mode control | 仅PN65N |
引脚功能
| 类别 | 引脚名称 | 引脚号 | 描述 | 备注 | | Host connection pins | VEN | 34 | Enable/disable LDO regulator |
| | PVDD | 40 | Pad supply voltageInput(VI/O) |
| | PMUVCC | 35 | UICC Power in from PMU |
| | IRQ | 42 | IRQ output |
| | TXD/SCL/MISO (IF3) | 43 | Functionality depends on selected interface |
| | SDA/SCK (IF2) | 39 | Functionality depends on selected interface |
| | RXD/A1/MOSI (IF1) | 41 | Functionality depends on selected interface |
| | A0/NSS (IF0) | 8 | Functionality depends on selected interface |
| | NRESET | 37 | PN544有用，PN65N中接PVDD |
| | UICC connection pins | SIMVCC | 33 | Power output to supply the UICC |
| | SWP | 32 | SWP data connection |
| | EXT_SW_CTRL | 3 | Control output signal for external UICC power switch |
| | SE connection pins | SVDD | 31 | SmartMX power,fixed to 1.8V |
| | SIGIN | 26 | NFC-WI data input |
| | SIGOUT | 30 | NFC-WI data output |
| | CLK | 36 | CLK pin of ISO IEC 7816 interface of SmartMX | 仅PN65N | | I/O1 | 28 | IO pin of ISO IEC 7816 interface of SmartMX | 仅PN65N | | RST_N | 16 | RST pin of ISO IEC 7816 interface of SmartMX | 仅PN65N | | Antenna connection pins | TX1 | 21 | Contactless Transmitter output1 |
| | TX2 | 22 | Contactless Transmitter output2 |
| | RX | 18 | Contactless Receiver input |
| | VMID | 17 | Contactless receiver Voltage reference |
| | PF1 | 19 | Antenna connection for card emulation |
| | PF2 | 23 | Antenna connection for card emulation |
| | GPIO pins | GPIO4 | 46 | Download mode control | 仅PN65N | | GPIO5 | 45 | Run mode selection | 仅PN65N | | Configuration pins | IFSEL0 | 44 | Host interface select input 0 |
| | IFSEL1 | 15 | Host interface select input 1 |
| | IFSEL2 | 14 | Host interface select input 2 |
| | Other pins | VBAT | 29 | Battery voltage |
| | GND | 1 | Ground |
| | GND | 24 | Ground |
| | VEN_MON (LX) | 27 | DCDC coil | PN544 | | Enable of the battery voltage monitor | PN65N | | NC | NC | 2 |
|
| | 4 |
|
| | 5 |
|
| | 6 |
|
| | 7 |
|
| | 9 |
|
| | 10 |
|
| | 11 |
|
| | 12 |
|
| | 13 |
|
| | 20 |
|
| | 25 |
|
| | 38 |
|
|
|
具体成交价以合同协议为准
免费会员·3年
